[
    {
        "role": "user",
        "content": "for%20the%20Navimow%20i206%20AWD%20mower%2C%20I%20have%20the%20Navimow%20garage.%20Where%20do%20these%20little%20side%20walls%20go%3F"
    },
    {
        "role": "assistant",
        "content": "Hi! I couldn\u2019t find anything in official Navimow documentation that describes \u201clittle side walls\u201d as part of the standard garage kit\u2014it appears the OEM garage doesn\u2019t include full side panels, just the base, the back, and a flip-up/roof cover. ([segwaynavimow.zendesk.com](https://segwaynavimow.zendesk.com/hc/en-us/article_attachments/54515859682713?utm_source=openai))\n\nIf you\u2019ve got \u201cside walls\u201d (either extras from a kit, DIY panels, or something custom), here\u2019s how people are using them and what to consider:\n\n---\n\n### What the OEM Garage Includes\n\n- The **Garage S** for i-series (including your i206 AWD) gives protection against sun and rain with a base, back, and a roof/cover. ([segwaynavimow.zendesk.com](https://segwaynavimow.zendesk.com/hc/en-us/article_attachments/54515859682713?utm_source=openai))  \n- It has a flip-up cover so you can access the mower\u2019s controls panel on the charging station. ([segwaynavimow.zendesk.com](https://segwaynavimow.zendesk.com/hc/en-us/article_attachments/55039478405145?utm_source=openai))  \n\nSo, \u201cside walls\u201d aren\u2019t part of the standard design. Anything extra is likely added by users or as a customization.\n\n---\n\n### How Users Add Side Walls / Panels\n\nFrom user-built garages and discussion forums:\n\n- Many add **partial side panels** to block wind, rain, or plants. These panels are often short (not full height) to allow the mower to see out the side cameras. ([reddit.com](https://www.reddit.com/r/SegwayNavimow/comments/1sl6e5f/suggestions_for_custom_garage_for_navimow_x420/?utm_source=openai))  \n- Full height or enclosed sides sometimes lead to issues: The mower may **turn too early** as soon as its side cameras emerge, causing it to rap into the side wall. ([reddit.com](https://www.reddit.com/r/SegwayNavimow/comments/1sl6e5f/suggestions_for_custom_garage_for_navimow_x420/?utm_source=openai))  \n- Also, fully closed panels can degrade GPS / GNSS signal reception. The official advice repeatedly warns avoiding metal, keeping things open and using plastic for garages/shelters. ([navimow-support.zendesk.com](https://navimow-support.zendesk.com/hc/en-us/articles/54623745795481--Navimow-i-Can-I-place-a-garage-shelter-for-Navimow-i?utm_source=openai))  \n\n---\n\n### Where to Put the Side Walls (If Using Them)\n\nIf you decide to add these little side walls, here\u2019s how to position them so they assist without interfering:\n\n- Install them on the **left and/or right sides** of the garage, leaving the **front open** so the mower can drive out cleanly.  \n- Make them **short enough** so that the mower\u2019s side sensors/cameras can still see outside the garage. Tight fits can cause the mower to start turning before it is clear, leading to bumping. ([reddit.com](https://www.reddit.com/r/SegwayNavimow/comments/1sl6e5f/suggestions_for_custom_garage_for_navimow_x420/?utm_source=openai))  \n- If possible, **angle or taper** the walls slightly so the mower backs out without immediately encountering vertical surfaces.  \n- Ensure there\u2019s enough vertical clearance so nothing touches the top of the mower (especially the camera / sensor area) when exiting.\n\n---\n\nIf you want, I can sketch out a precise diagram for your garage + side wall setup for the i206 AWD to help you see where everything should go. Do you want that?"
    }
]